Better Printed Jigs
For building the Micron 180mm
I made a new set of Jigs to align the X, Y and Z rails on the Micron 180mm extrusions.
The X original jigs only aligned it vertically for you but not horizontally. The Y original jig was good but did not work for the 180mm Micron. These are improved jigs that let you do alignment completely by themselves, by just pushing them against the ends of the extrusions and placing the rail in the space between them. Print two of each.
The Z jig had the correct length but its tiny arms meant that you needed to either have the L extrusion already there or a 90 degree block to keep it steady. The new Z-jig allows you to press on one side of the extrusion to get the 36mm spacing just right, and can also align the rail laterally on the extrusion when used vertically.
Slice with the voron part settings.
They should print well on no shrinkage compensation and only be slightly loose if you already have shrinkage compensation.
Files:
Last updated